Resetting a Yealink Cordless Base Station and Handset Pairing

Resetting the Cordless Base Station

1. Disconnect network cable (and power cable if there is one)
2. Hold the “Connect” button on the front and then connect the power and network cables.
3. Continue holding the “Connect” button until the 3 lights show green.
4. Disconnect power, and then reconnect.  The unit will then factory reset.  This can take a few minutes.  When reset, the bottom 2 lights will show green.
5. After factory reset, you will need to pair any handsets.

Yealink Cordless Handset Pairing

1. Press and hold the “Connect” button for 2 seconds.  The registration light (top light with the handset symbol) will flash green.
2. Power on the handset if necessary by hold in the red handset key
3. On the handset, press “OK” to enter the menu, and navigate to settings
4. Select “Registration”  -> “Register Handset” ->Base 1
5. If the phone was previously connected to a base unit, it will ask to ‘Replace Base’
6. It will show the mac address of the base.  Click OK
7. It will ask for the PIN.  By default, this is 0000.
8. Click “Done” and the handset will be registered.